Displacement Transducer



The DTJ-A-200 is a displacement transducer for both tension and compression measurement. It can measure up to 200 mm displacement.
Rated Capacity: 200 mm
Nonlinearity: Within ±0.3% RO
Measuring Force: Approx. 5.9 N
Rated Output: 5 mV/V ±0.3%


• High output 5 mV/V
• Temperature effect on zero within ±0.02% RO per ºC
• With scale
• TEDS-installed versions can be manufactured.

Products table

All display

200 mm



Rated Capacity 200 mm
Nonlinearity Within ±0.3% RO
Hysteresis Within ±0.3% RO
Repeatability 0.3% RO or less
Rated Output 5 mV/V ±0.3%
Environmental Characteristics
Safe Temperature -10 to 70ºC (Non-condensing)
Compensated Temperature 0 to 60ºC (Non-condensing)
Temperature Effect on Zero Within ±0.02% RO/ºC
Temperature Effect on Output Within ±0.02%/ºC
Electrical Characteristics
Safe Excitation 6 V AC or DC
Recommended Excitation 1 to 4 V AC or DC
Input Resistance 350 Ω ±1%
Output Resistance 350 Ω ±1%
Cable 4-conductor (0.065 mm2) vinyl shielded cable, 4 mm diameter by 2 m long, terminated with a connector plug PRC03-12A10-7M
(Shield wire is not connected to the case.)
Mechanical Properties
Frequency Response DC to approx. 2 Hz
Measuring Force Approx. 5.9 N
Weight Approx. 560 g (Excluding cable)
Optional Accessories Extension rods EB-50, EB-100, EB-200, EB-300
Replacement probes X, XS, SH
Magnet base MB-B



Page Top

To Ensure Safe Usage

Fix the transducer to the steady point using two M6 bolts.


(Note 1) Initial unbalance with the rod fully extended is approximately-5000 to -6000 ×10-6 strain.
(Note 2) Avoid usage in vibration.
(Note 3) If large displacement is applied momentarily, it takes some time that output is settled.
(Note 4) Do not apply any displacement in other than expansion/ contraction direction of the rod.



Recommended products for combination