LBT-D-100NSA1-H
Seat Belt Tension Transducer for CRS

Summary

To use for measuring tensile force to install CRS (Child Restraint Seat)
Measure the sensor of seat belt tension. Compact, lightweight and disassembly-friendly design.

Products table

All display

LBT-D-100NSA1-H
100 N

Specifications

Performance
Rated Capacity 100 N
Nonlinearity Within ±1.5% RO (With a built-in compensation circuit)
Rated Output Approx. 1 mV/V
Environmental Characteristics
Safe Temperature 0 to 60ºC
Compensated Temperature 10 to 50ºC
Temperature Effect on Zero Within ±0.1% RO/ºC
Electrical Characteristics
Safe Excitation 10 VDC
Recommended Excitation 2 to 10 VDC
Input Resistance 700 to 900 Ω
Output Resistance 700 Ω ±3%
Insulation Resistance 500 MΩ or more (With 25 VDC applied)
Cable 4-conductor (0.08 mm2) vinyl shielded cable, 3.2 mm diameter by 5 m long, terminated with a connector plug
PRC03-12A10-7M
(Shield wire is not connected to the case.)
Mechanical Properties
Safe Overloads 120%
Enclosure Metallic finish
Materials Aluminum alloy
Weight Approx. 65 g
Others Not waterproofed.
Single belt calibration (Our standand seat belt)
Because this product has a built-in compensation
circuit, use with excitation voltage of 2 to 10 VDC.
(No specifications guarantee if less than 2 V excitation is used.)
Data on the "Test Data Sheet" is based on 2 V bridge excitation..
Cable Box with a built-in compensation circuit is located
approx. 300 mm far from the cable end.
Note) Characteristic values are based on our calibration methods
and conditions.
*We accept calibration for the supplied seat belt.

Dimensions

LBT-D

Page Top

Remarks

Note) Characteristic values are based on our calibration methods and conditions.
*We accept calibration for the supplied seat belt.

eBook

Recommended products for combination